Cancelling Direct-To Navigation; Specifying A Course To A Waypoint - Garmin GPS 400W Pilot's Manual & Reference

Cancelling Direct-To Navigation

Once a direct-to is activated, the 400W-series will
provide navigation guidance to the selected destination
until the direct-to is replaced with a new direct-to or
flight plan, cancelled, or the unit is turned off.
To cancel a direct-to:
Press the direct-to key to dsplay the select
1.
drect-to waypont page.
2. Press MENU to dsplay the drect-to optons
menu.
3. Wth "Cancel Drect-To NAV?" hghlghted,
press ENT. If a flght plan s stll actve, the
400W-seres wll resume navgatng the flght
plan along the closest leg.

Specifying a Course to a Waypoint

Whenever you perform a direct-to, the 400W-
series will set a direct geodesic course to your selected
destination. You can also manually define the course to
your destination, using the "CRS" course field on the
select direct-to waypoint page.
To manually define the direct-to course:
Press the direct-to key.
1.
2. Use the small and large right knobs to select
the destnaton waypont.
Press ENT to confirm the selected waypont,
3.
then turn the large right knob to hghlght
the course ("CRS") field.
4. Turn the small and large right knobs to select
the desred course and press ENT.
5. Press ENT agan to begn navgaton usng the
selected destnaton and course.
6. To reselect a drect course from present pos-
ton (or select a new manually-defined course),
smply press direct-to, followed by ENT
twce.
190-00356-00 Rev B
3 - DIRECT-TO
Cancelling / Manual Course
65