Multiple Paging Group Parameters - Cisco SPA 501G Administration Manual

Cisco SPA 500 Series and Wireless IP Phone Field Reference
Phone Tab
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
Parameter
Speakerphone Input Gain
Handset Additional Input Gain
Headset Additional Input Gain
Speakerphone Additional
Input Gain

Multiple Paging Group Parameters

Parameter
Group Paging Script
Description
The amount of amplification to apply to the audio input
signal for the speakerphone.
Defaults to zero.
Applies additional input gain to the handset.
Applies additional input gain to the headset.
Applies additional input gain to the speakerphone.
Description
You can configure a phone as part of a paging group.
Users can then direct pages to specific groups of
phones. A phone can be part of no more than two
paging groups, and user can page a maximum of five
paging groups.
The syntax is as follows:
pggrp=ip-address:port;[name=xxx;]num=xxx;
[listen={yes|no}]];
Where:
IP address
: Multicast IP address of the phone that will
listen for and receive pages.
port
: Port on which to page; you must use different
ports for each paging group.
name (optional): The name of the paging group.
num: The number users will dial to access the paging
group; must be unique to the group.
listen: If the phone should listen on the page group. Only
the first two groups with listen set to yes will listen to
group pages. If the field is not defined, the default value
is no, so you must set this field to listen to the group
pages.
B
254