Chapter 4: Configuring Sip, Spcp, And Nat; Session Initiation Protocol And Cisco Ip Phones - Cisco SPA 501G Administration Manual
Small business pro
Hide thumbs
Also See for SPA 501G:
- Administration manual (311 pages) ,
- User manual (95 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Configuring SIP, SPCP, and NAT
Session Initiation Protocol and Cisco IP Phones
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
The Cisco SPA 500 Series and Wireless IP Phones use the following protocols:
•
Session Initiation Protocol (SIP)—Cisco SPA 500 Series, WIP310
•
Cisco Smart Phone Control Protocol (SPCP)—Cisco SPA 500 Series
This chapter describes how to configure the phone protocols and other
parameters. It contains the following sections:
•
Session Initiation Protocol and Cisco IP Phones, page 78
•
Configuring SIP, page 81
•
Configuring SPCP on the Cisco SPA 525G, page 101
•
Configuring SPCP on the Cisco SPA 50XG, page 102
•
Network Address Translation (NAT) and Cisco IP Phones, page 102
Cisco IP phones use Session Initiation Protocol (SIP), allowing interoperation with
all ITSPs supporting SIP.
SIP handles signaling and session management within a packet telephony
Signaling
network.
allows call information to be carried across network
Session management
boundaries.
The following diagram shows a SIP request for connection to another subscriber
in the network.
In typical commercial IP telephony deployments, all calls go through a SIP proxy
server. The requesting phone is called the SIP user agent server (UAS), while the
receiving phone is called the user agent client (UAC).
controls the attributes of an end-to-end call.
4
78
Advertisement
Table of Contents
