Secure Call Indication Tone - Cisco SPA 501G Administration Manual

Configuring Security, Quality, and Network Features
Setting Security Features
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
NOTE
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
To enable the secure call service:
Log in to the web administration interface.
Click Admin Login and advanced.
Click the Phone tab.
In the Supplementary Services section, under Secure Call Serv, choose yes.
Click Submit All Changes.
This feature can also be configured from the User tab, under Supplementary
Services.
Users can enter *18 to Secure Next Call—Uses encrypted media for the next
outbound call (on this call appearance only). This star code is redundant if all
outbound calls are secure by default.
The phone can be configured for secure provisioning using the factory-installed
security certificate. To determine if the Client Certificate is installed on the phone:
• SPA 50XG: Press the Setup button and select Product Info. Scroll to Client
Cert.
• SPA 525G: Press the Setup button and select Status. Select Product
Information. Scroll to Certificate.
• WIP310: Log in to the web administration interface. In the Info tab, under
Product Information, certificate information is listed in the Client Certificate
field.

Secure Call Indication Tone

This tone is played when a call has been successfully switched to secure mode. It
should be played only for a short while (less than 30 seconds) and at a reduced
level (less than -19 dBm), so it does not interfere with the conversation. You can
Regional
configure it on the
Defaults to 397@-19,507@-19;15(0/2/0,.2/. 1 /1,. 1 /2. 1 /2)
Call Progress Tones
web page under
5
.
111