Cisco SPA 501G Administration Manual page 29

Getting Started
Using IVR on the Cisco SPA 501G IP Phone
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
Number Option
221 Set call control—enter the value for the call control method you want,
then press #:
•
0: SIP
•
1: SPCP
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
73738 Restore the phone to the factory default software and settings.
Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
begin the restore process.
87778 Restore the phone's user settings to the default. (Clears all user settings
such as speed dials.)
Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
begin the restore process.
732668 Reboot the phone. After entering #, hang up to begin rebooting.
111 Set a static IP address. Enter the address (use * to enter the "." value),
then press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE
disabled, you receive an error message.
121 Set a netmask. Enter the address (use * to enter the "." value), then
press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE
disabled, you receive an error message.
131 Set a gateway. Enter the address (use * to enter the "." value), then
press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE
disabled, you receive an error message.
161 Set the address of the primary Domain Name Server (DNS). Enter the
address (use * to enter the "." value), then press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
DHCP must be disabled to use this option; if DHCP is not
DHCP must be disabled to use this option; if DHCP is not
DHCP must be disabled to use this option; if DHCP is not
1
18