Vlan Settings - Cisco SPA 501G Administration Manual

Cisco SPA 500 Series and Wireless IP Phone Field Reference
System Tab
NOTE
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
Parameter
Enable Bonjour

VLAN Settings

Not applicable to the WIP310.
Parameter
Enable VLAN
Enable CDP
VLAN ID
Enable PC Port VLAN Tagging
PC Port VLAN Highest Priority
PC Port VLAN ID
Description
Enable Bonjour networking that is used by Office
Manager and Cisco Configuration Assistant to discover
the Cisco IP phones. Choose yes to enable or no to
disable.
Description
Choose Yes to enable VLAN. Choose no to disable.
Enable CDP
only if you are using a switch that has
Cisco Discovery Protocol. CDP is negotiation based
and determines which VLAN the IP phone resides in.
If you use a VLAN without CDP (VLAN enabled and
CDP disabled), enter a
that only voice packets are tagged with the VLAN ID.
Enables VLAN and priority tagging on the phone data
port (802. 1 p/q). This feature facilities tagging of the
VLAN ID (802. 1 Q) and priority bits (802. 1 p) of the traffic
coming from the PC port of the IP phone.
Defaults to No. Choose Yes to enable the tagging
algorithm.
0-7 (default 0). The priority applied to all frames,
tagged and untagged. The phone modifies the frame
priority only if the incoming frame priority is higher than
this value.
0-4095 (default 0). Value of the VLAN ID. The phone
tags all the untagged frames coming from the PC (it will
not tag frames with an existing tag).
VLAN ID
for the IP phone. Note
B
207