Setting Up The Cisco Spa 500S Attendant Console - Cisco SPA 501G Administration Manual

Configuring the Cisco SPA 500S Attendant Console

Setting Up the Cisco SPA 500S Attendant Console

Setting Up the Cisco SPA 500S Attendant Console
STEP 1
STEP 2
STEP 3
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
To configure the server to use the Cisco SPA 500S, configure each extension that
will be monitored by the attendant console. The Cisco SPA 500S is a SIP
subscriber in relation to each SIP proxy server, which allows the Cisco SPA 500S
to receive NOTIFY messages from the SIP proxy that indicate the status of each
monitored phone. In general, the SIP proxy is identified by its IP address, or
through a hostname if DNS is configured. The way in which each phone and
extension is identified is vendor-specific.
To set up the Cisco SPA 500S attendant console:
Complete the physical installation of the Cisco SPA 500S unit, which connects it to
the phone. For instructions on installing the Cisco SPA 500S and an introduction to
its use, refer to the Cisco SPA 500S Quick Start Guide or the phone user guides
available on Cisco.com. See
those guides.
Configure one of the following SIP proxy servers:
• Cisco SPA 9000—See
SPA 500S, page 181
supports the Cisco SPA 500S).
• BroadSoft—See
500S, page 181.
• Asterisk—See
page 182.
Configure the Cisco SPA 500S using the web UI. The web server must be
connected to the phone to which the Cisco SPA 500S is physically attached.
CTI must be enabled on the phone for an attached Cisco SPA 500S to
NOTE
properly monitor the IP phone's line status when the SIP proxy server type is
set to Cisco SPA 9000. See the "Configuring SIP" section on page 89.
Appendix C, "Where to Go From Here,"
Configuring the Cisco SPA 9000 for the Cisco
(verify that your version of the Cisco SPA 9000
Configuring the BroadSoft Server for the Cisco SPA
Configuring the Asterisk Server for the Cisco SPA 500S,
9
for a list of
180