Cisco SPA 501G Administration Manual page 237

Cisco SPA 500 Series and Wireless IP Phone Field Reference
Regional Tab
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
Parameter
SIT4 Tone
MWI Dial Tone
Cfwd Dial Tone
Holding Tone
Conference Tone
Secure Call Indication Tone
Page Tone
Alert Tone
System Beep
Description
This is an alternative to the Reorder Tone played when
an error occurs as a caller makes an outbound call. The
RSC to trigger this tone is configurable on the SIP
screen.
Defaults to 985@-16,1371@-16,1777@-16;20(.380/0/
1,.274/0/2,.380/0/3,0/4/0).
Played instead of the Dial Tone when there are unheard
messages in the caller's mailbox.
Defaults to 350@-19,440@-19;2(. 1 /. 1 /1+2);10(*/0/1+2).
Played when all calls are forwarded.
Defaults to 350@-19,440@-19;2(.2/.2/1+2);10(*/0/1+2).
Informs the local caller that the far end has placed the
call on hold.
Defaults to 600@-19*(. 1 /. 1 /1,. 1 /. 1 /1,. 1 /9.5/1).
Played to all parties when a three-way conference call
is in progress.
Defaults to 350@-19;20(. 1 /. 1 /1,. 1 /9.7/1).
Played when a call has been successfully switched to
secure mode. It should be played only for a short while
(less than 30 seconds) and at a reduced level (less than
-19 dBm) so it does not interfere with the conversation.
Defaults to 397@-19,507@-19;15(0/2/0,.2/. 1 /1,. 1 /2. 1 /2).
Specifies the tone transmitted when the paging feature
is enabled.
Defaults to 600@-16;.3(.05/0.05/1).
Played when an alert occurs.
Defaults to 600@-19;.2(.05/0.05/1).
Audible notification tone played when a system error
occurs.
Defaults to 600@-16;. 1 (.05/0.05/1).
NOTE WIP310 and Cisco SPA 525G only.
B
226