4.5DDNS Setup Menu
GadgetGateway Serial Interface
4.5.18 Set DDNS Refresh time
Select [T] from the menu and press ENTER.
>>>t
Enter DDNS Refresh Time
Rate in seconds >>>
Input the number of seconds between refreshes of the DDNS information. If you press
ENTER without typing in anything the previous value is retained.
When the refresh time expires the node does a DNS lookup on its own DDNS name to see
if its own NAT routers' IP address has changed. If its IP address has changed it will then
notify the other nodes in the channel to update their record of the changed nodes IP
address.The refresh time determines how long the node goes between checks of its IP
address. In addition, when the refresh time expires, the node also does a DNS lookup on
any nodes in its channel list with zero stored for their IP addresses.
4.5.19 Set DNS Servers
Select [V] from the menu and press ENTER.
>>>v
Enter DNS Server #0 IP address[0.0.0.0] >>>
Enter DNS Server #1 IP address[0.0.0.0] >>>
Enter DNS Server #2 IP address[0.0.0.0] >>>
the node will prompt in order for the IP address for each of the three IP servers. Enter the
IP addresses in the format shown (xx.xxx.xx.xx). If you press ENTER without typing in
anything the previous value is retained.
4.5.20 Lookup DDNS IP Address
Select [L] from the menu and press ENTER. This will force an immediate DNS lookup of
the nodes IP address. The DDNS IP address displayed on the screen will be updated. This
can be used in setup and testing to make sure the DNS lookups work.
4.5.21 Reboot GadgetGateway
Select [Q] from the Main Menu and press ENTER. The main processor on the Gadget-
Gateway will reboot. This makes it easier to reboot when changing configurations such as
852 to 852 bridging mode or when changing the web server port. A few seconds after the
reboot selection is executed the GG boot up screens will be displayed.
4-17