Table of Contents
Advertisement
2.4Connectors and Indicators
GadgetGateway Overview
2.4 Connectors and Indicators
1. Serial/Counsel Setup Port: Interface to the Serial Setup Menus.
2. Ethernet/IP connector: Used to connect the Gateway to an IP network.
3. Ethernet Link Indicator LED: The indicator turns green when the Gateway has a valid
physical connection to the IP network and goes off when there is no connection.
4. Service Pin 1: Service Pin used for installation of the GadgetGateway router.
5. Service Pin 1 LED indicator: The indicator flashes orange when Service Pin 1 is
pressed.
6. Service Pin 2 LED indicator: The indicator flashes orange when Service Pin 2 is
pressed.
7. Service Pin 2: Alternate service Pin used for installation of the GadgetGateway router
when not in Twin Mode. When in Twin mode, service pin used for installing the monitor-
ing application.
8. Power Supply Input: Used to attach the power supply to the Gateway.
9: Power Indicator: The indicator turns red when power is being provided to the Gateway.
10. Orange LED: Reserved for future use.
11. Green LED: Reserved for future use.
12. Network Traffic Indicator: The indicator flashes green when network traffic is detected
on the LON side network.
13. ANSI/EIA 709.1 Interface: Used to connect the Gateway to the LonWorks network.
2.5 Redundant Twin Mode
The Twin Redundancy mode enables two GadgetGateway routers to operate as a redun-
dant pair for high availability applications. This enhanced capability increases reliability
and eliminates some single mode failure sources.
2-9
Advertisement
Table of Contents
