Restoring Node Ids Or Mac Addresses In Version 2.Xx Firmware; Restoring Node Ids; Restoring The Ethernet Mac Address - adept technology GadgetGateway User Manual

6.4Restoring Node IDs or MAC Addresses
GadgetGateway Firmware Upgrade
in Version 2.xx Firmware
6.4 Restoring Node IDs or MAC Addresses in Version 2.xx
Firmware

6.4.1 Restoring Node IDs

With the serial console set up
Power cycle the device
Wait for the prompt to press any key to change parameters.
Press any key with in the 5 seconds.
The next prompt will ask for A or M. Don't type either.
Instead type in (case sensitive) the word GADGET_NID and press return.
It will prompt for the first Node ID.
Enter the Node ID (from the label) in the following format (XX replaced with Hex digits
from the ID)
XX.XX.XX.XX.XX.XX so it looks something like 80.00.00.00.81.DE
Press return.
It will prompt for the second NodeID.
Enter it and press return.
It will then prompt for a third NodeID. This one is only used if Twin Mode is enabled.
Either enter the third ID if you have it or enter nothing and press return.
Press return a second time and it will prompt to Accept or Modify
Type M for modify and press return
Then press return at each of the succeeding prompts to accept the defaults.
The last prompt will say.
Saving the changes in NV memory...Done.
The default boot prompt should then come up and you should be able to go through the
menus and confirm the Node IDs.

6.4.2 Restoring the Ethernet Mac Address

With the serial console set up
6-7