Configuring With The Coactive Router -Ll; Configuring With The Coactive Router-Ll; Manual Mode; Router -Ll Configuration Server Mode - adept technology GadgetGateway User Manual

Table of Contents

3.5 Conﬁguring with the Coactive Router-

3.5 Conﬁguring with the Coactive Router-LL

This section contains step-by-step instructions on conﬁguring a Coactive Router-LL and a

GadgetGateway in Manual mode to tunnel ANSI/EIA 709.1 packets between each other.

This creates an IP backbone for a ANSI/EIA 709.1 network.

1. Using the Serial connection, set up an IP address, subnet mask, and Gateway address

for the GadgetGateway (See Section 4.2, "GadgetGateway IP Configuration" ). Using

a PC, ping the Gateway to ensure that it is communicating on the IP network.

Note: Consult the network administrator to procure the IP address, subnet mask, and

Gateway address, if not already known.

2. Set both the GadgetGateway and the Coactive Router-LL to Manual mode. For the

Gateway, this can be done through either the 709.1/IP Gateway Main Menu in the

Serial Menu or through the Router Setup page on the Web Interface (Section 4.4 or

Section 5.4). For the Router-LL, this is done through the Basic Setup on the Router-

LL's Web Interface (Section 5.4).

3. Using either the Serial Interface or the Web Interface, add the other device's IP address

and communications port number (the default port is 1628) into the Channel List of the

Gateway and the Router-LL (Section 4.4.12 or Section 5.4).

4. Once steps 1–3 have been completed, the GadgetGateway will be able to communicate

with the Coactive Router-LL over the IP network. The devices can now be set up and

commissioned using the LonMaker Management Tool or any other compatible man-

agement tool.

3.5.2 Router-LL Conﬁguration Server Mode

This section contains step-by-step instructions on conﬁguring an Coactive Router-LL

and a GadgetGateway using the Router-LL Conﬁguration Server to tunnel ANSI/EIA

709.1 packets between each other. This will create an IP backbone for a ANSI/EIA 709.1

network.

1. Using the serial connection, set up an IP address, subnet mask, and Gateway address

for the GadgetGateway (See Section 4.2, "GadgetGateway IP Configuration" ). Using

a PC, ping the Gateway to ensure that it is communicating on the IP network.

Note: Consult the network administrator to procure the IP address, subnet mask, and

Gateway address, if not already known.

3-6

GadgetGateway Startup Guide

Table of Contents