Set Configuration Server Address; Set Configuration Server Port - adept technology GadgetGateway User Manual

GadgetGateway Serial Interface
4.4 709.1/IP Gateway Setup Menu
4.4.12 Set Configuration Server Address
This item is only displayed in the menu when the router is set to Normal mode.
When 852 bridge mode is enabled there are two configuration servers, one for each of the
bridged channels, that is, far side and near side. To set the far side configuration server
address when in 852 bridge mode or to set the single config server address when not in
bridge mode:
Select [A] from the menu and press ENTER.
Enter the Config Server Address:
Enter the Configuration Server's IP Address in the format X.X.X.X and press ENTER.
The new address will appear in the menu. If you press ENTER without typing in anything
the previous value is retained.
To set the near side configuration server address when in 852 bridge mode:
Select [Y] from the menu and press ENTER.
Enter the Near Side Config Server Address:
Enter the near side Configuration Server's IP Address in the format X.X.X.X and press
ENTER. The new address will appear in the menu. If you press ENTER without typing in
anything the previous value is retained.
4.4.13 Set Configuration Server Port
This item is only displayed in the menu when the router is set to Normal mode.
When 852 bridge mode is enabled there are two configuration servers, one for each of the
bridged channels, that is, far side and near side. To set the far side configuration server
port when in 852 bridge mode or to set the single config server port when not in bridge
mode:
Select [C] from the menu and press ENTER. If you press ENTER without typing in any-
thing the previous value is retained.
Enter the Config Server IP Port:
Enter the Configuration Server's Communication Port (0-65534) and press ENTER. The
new port will appear in the menu.
To set the near side configuration server port when in 852 bridge mode:
Select [Z] from the menu and press ENTER. If you press ENTER without typing in any-
thing the previous value is retained.
Enter the Near Side Config Server IP Port:
Enter the near side Configuration Server's Communication Port (0-65534) and press
ENTER. The new port will appear in the menu.
4-14