Table of Contents
Advertisement
6.5Current Firmware Features and
GadgetGateway Firmware Upgrade
Updates
Changes Present in firmware version 2.10 from version 2.00B17
* The GadgetGateway will now register itself to its configuration server on power up.
Changes Present in firmware version 2.00B17 from version 2.00B9 -----------------
* A Bug was fixed that caused the GadgetGateway to periodically freeze up.
* A Bug was fixed that caused the GadgetGateway to sometimes revert to default IP and
MAC addresses under heavy traffic.
* A new menu option was added to the LT/IP Gateway Main Menu giving the user the
ability to instigate a Device Configuration message being sent to the configuration server.
This option is only available in Normal Mode.
* A Bug in the 709.1b side driver was fixed. This bug caused the node to not transmit
709.1 messages when there was moderate traffic on the channel.
* Many fixes to the 852 ( 709.1 over IP ) protocol were were implemented.
* The statistics on both the webpage and serial menu have been fixed so that they now
show the correct values.
* A new compatibility mode was added so that the GadgetGateway will pass the
i.LON(TM) Configuration servers diagnostic tests. To use the i.LON compatibility mode,
use the serial console to navigate to the LT/IP Gateway Main Menu. Then select the
i.LON compatibility mode from the menu options. Note: This option is only available in
normal mode.
* A new compatibility mode was added so that the GadgetGateway work with a Coactive
LL router that is a configuration server. To use the new compatibility mode, use the serial
console to navigate to the LT/IP Gateway Main Menu. Then select the Coactive compati-
bility mode from the menu options. Note: This option is only available in normal mode.
* Many other bug fixes and stability fixes were added
Changes Present in firmware version 2.00B9 from version 2.00B3 -----------------
* A new version of the FPGA firmware and a new associated driver have been imple-
mented
* Version 2.00B9 is now persistent after power cycles. Previous versions sometimes had
problems communicating with Management tools following a power cycle.
* Lonmaker will now report the status of the gateway correctly including after power
cycles.
* The Gateway now correctly sends out the 852 Registration message on start up so that
the configuration server correctly updates its channel list
* Throughput of the gateway has been improved greatly.
6-11
Advertisement
Table of Contents
