Table of Contents
Advertisement
4.1 Introduction
Chapter 4:
GadgetGateway Serial Interface
4.1 Introduction
The GadgetGateway Serial-based Interface allows the user to access and change configu-
ration data on the GadgetGateway by using the Gateway's serial port. The serial configura-
tion interface gives the user complete control over the GadgetGateway and all of its
configuration information. This chapter will familiarize the user with the screens used in
the Serial Interface to configure the GadgetGateway for operation.
4.2 GadgetGateway IP Configuration
Upon booting up the GadgetGateway, two introductory prompts will appear, one after
another. For each prompt the Gateway will pause for a few seconds. The length of the
pause can be set by the user. If no key is pressed by the end of the pause, the next prompt
is displayed. If no key is pressed by the end of the second pause then the Main Menu is
displayed. If the prompts are missed or disappear too quickly, simply reset or power cycle
the Gateway and wait approximately 30 seconds until the prompts reappear.
The first prompt allows you to reprogram or update the Gateways firmware stored in flash
memory.
Adept Systems Inc. GadgetGateway
Boot-loader Version 2.0
Press any key with in 3 seconds to reprogram flash memory.
If no key is pressed the console with print out
Attempting to load resident flash program.
Note: The process of reprogramming flash memory is explained in Chapter 6.1, "Firm-
ware Upgrade Instructions".
Shortly thereafter the second prompt will be displayed.
The second prompt allows you to modify the Gateway's IP settings
GadgetGateway Startup Menu
NetOS V5.0
Copyright (c)2003 Adept Systems Inc.
=============================================================================
***Network Settings***
IP Address
Subnet Mask
4-4
: 10.0.2.95
: 255.255.255.0
GadgetGateway Serial Interface
Advertisement
Table of Contents
