USING THE CONTROL PANEL
V1
***
I1
***
8-6
EATON Powerware
8.2.3
Unit Meter Screens
The Unit Meter screens show the UPS meter readings for the unit (or units, if a
parallel system is installed). The default voltage displayed on these screens is
phase-to-neutral. However, an authorized Eaton Customer Service Engineer can
change the screens to display the voltage phase-to-phase (A-B, B-C, C-A).
Press the METERS pushbutton on the main menu bar to display the Unit Meter
screens. Figure 8‐6 through Figure 8‐10 show the Unit Meter screens.
To scroll through the meter screens, press the
The current UPS readings are displayed in the information area of the screen.
NOTE The UNIT designation after the meter type, and the SYSTEM and UNIT menu bar pushbutton
selections, are visible only when a parallel system is installed.
The Output screen shows output voltage (phase‐to‐neutral), output current (each
phase), and frequency being supplied by the UPS, as well as the kVA, kW, and power
factor measurements.
OUTPUT - UNIT
V2
V3
***
***
I2
I3
***
***
Figure 8‐6. Unit Output Meter Screen
®
9390 UPS (20–80 kVA) Installation and Operation Manual
KVA
KW
***
***
FREQ
PF
***
***
SYSTEM
UNIT
S
164201603 Rev 2 www.powerware.com
or
pushbuttons on the menu bar.
LEAD