Table of Contents
Advertisement
5.4 UPS connection
Check that the indications on the name plate located on the back of the UPS correspond to the AC-power source
and the true electrical consumption of the total load.
5.5 Connection with a FlexPDU (Power Distribution Unit) optional module
5.6 Connection with a HotSwap MBP (Maintenance ByPass) optional module
The HotSwap MBP module makes it possible to service or even replace the UPS without affecting the connected loads
(HotSwap function).
614-40094-00
1. For the 5PX 1000 / 1500, connect the UPS input socket
(2) to the AC power source using the cable of the
protected equipment.
For the 5PX 2200 / 3000, connect the UPS input socket (2)
to the AC-power source using the cable (13) supplied.
2. Connect the loads to the UPS using the cables (14). It is
preferable to connect the priority loads to the
outlets marked (3) and the non-priority loads to the
outlets Group1, Group2 (4) that can be programmed.
For the 5PX 2200 / 3000 models, connect any high-power
devices or matching Power Distribution Unit (PDU) to
the 16A outlet.
Fit the connection securing system that prevents the
plugs from being pulled out accidentally.
3. To program shutdown and startup of the Group1 and
Group2 outlets in order to extend battery runtime and
perform scheduled shutdowns, please see the
settings" section.
1. 5PX 1000 / 1500 : Use the power cable of the protected
equipment.
5PX 2200 / 3000 connect the UPS input socket to the AC
power source using the cable (13) supplied.
2. Connect the input socket on the FlexPDU module (40)
to the UPS outlet (3) using the cable (24) supplied. The
cable and the connectors are marked in red.
3. Connect the equipment to the outlets (41) on the
FlexPDU module. These outlets differ, depending on the
version of the FlexPDU module.
4. Fit the connection securing system that prevents the
plugs from being pulled out accidentally.
"In/Out
14
Advertisement
Table of Contents
