Table of Contents
Advertisement
SDM-100A Satellite Modem
3.2.1.1.4 Configuration Local AUPC
AUPC Enable
Nominal Power
Minimum Power
Maximum Power
Target Noise
Tracking Rate
Local CL Action
Remote CL Action
Rev. 0
This option turns the local modem's AUPC ON or OFF.
This option programs the nominal power set point for AUPC from -30
to -5 dBm.
This option programs the minimum power set point for AUPC from -
30 to -5 dBm.
This option programs the maximum power set point for AUPC from -
30 to -5 dBm.
This option programs the target E
can range from 3.2 to 9.7 dB, in 0.1 dB increments.
This option programs the maximum tracking rate. The maximum
tracking rate can range from 0.5 to 6.0 dBm per minute.
This option programs the action taken by the local modem if Carrier
Loss is detected. The local CL can be programmed to Maximum,
Nominal, or Hold.
This option programs the action taken by the remote modem if
Carrier Loss is detected. The remote CL can be programmed to
Maximum, Nominal, or Hold.
/N
setpoint. The E
/N
setpoint
b
0
b
0
Operation
3–23
Advertisement
Table of Contents
