Table of Contents
Advertisement
Theory of Operation
4.4.1.2 Specification
Circuit Supported
Amplitude (RD, RT, ST, DM, RR)
DC Offset (RD, RT, ST, DM, RR)
Impedance (RD, RT, ST, DM, RR)
Impedance (SD, TT, MC)
Polarity
Phasing (RD, RT)
Symmetry (ST, TT, RT)
Frequency Stability (ST)
Modulator Fault
Demodulator Fault
4.4.2 V.35 Interface
The V.35 digital interface provides level translation, buffering, and termination between
the internal modem signals and the V.35 DCE interface on the rear panel. Electrical
characteristics of the interface signals are defined in CCITT Recommendation V.35. The
electrical and mechanical specifications are summarized in Sections 4.4.2.1 and 4.4.2.2.
Refer to Figure 4-7 for a functional block diagram of the interface.
The V.35 interface provides a Serial Clock Transmit (SCT) clock signal at the modem
data rate.
•
•
In either case, the phase relationship between the clock and data is not important, as long
as it meets the jitter specification. This is because a clock phase correction circuit is
provided, which shifts the clock away from the data transition times.
4–18
In the INTERNAL clock mode, the data to be transmitted, Send Data (SD), must
be synchronized to SCT.
In the EXTERNAL clock mode, the clock is accepted on the Serial Clock
Transmit External (SCTE) input to clock-in the data to be transmitted.
SD, ST, TT, RD, RT, DM, RR, MC, MOD FAULT,
DEMOD FAULT
4,
2V differential into 100
±
0.0,
0.4V
±
Less than 100
, differential
Ω
100,
20
, differential
±
Ω
True when B positive with respect to A
False when A positive with respect to B
False-to-True transition of RT nominally in center of RD
data bit
50%,
5%
±
100 PPM
±
Open collector output
15V max, 20 mA max current sink
Fault is open circuit
Open collector output
15V max, 20 mA max current sink
Fault is open circuit
SDM-100A Satellite Modem
Ω
Rev. 0
Advertisement
Table of Contents
