Figure 11-15 Ftp Session Example Of Firmware File Upload - ZyXEL Communications Prestige 314 PLUS User Manual

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
Step 7.
Enter "quit" to exit the ftp prompt.
FTP Session Example of Firmware File Upload
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> put firmware.bin ras
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 1103936 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit

Figure 11-15 FTP Session Example of Firmware File Upload

More commands (found in third party FTP clients), are listed earlier in this chapter.
Refer to the TFTP and FTP over WAN Will Not Work When section to read about configurations that
disallow TFTP and FTP to work over WAN.
11.4.3 TFTP File Upload
The Prestige also supports the uploading of firmware files using TFTP (Trivial File Transfer Protocol) over
LAN. Although TFTP should work over WAN as well, it is not recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To transfer the firmware and the
configuration file, follow the procedure shown next.
Step 1. Use telnet from your computer to connect to the Prestige and log in. Because TFTP does not have
any security checks, the Prestige records the IP address of the telnet client and accepts TFTP
requests only from this address.
Step 2.
Put the SMT in command interpreter (CI) mode by entering 8 in Menu 24 – System
Maintenance.
Step 3.
Enter the command "sys stdio 0" to disable the console timeout, so the TFTP transfer will not be
interrupted. Enter "command sys stdio 5" to restore the five-minute console timeout (default)
when the file transfer is complete.
11-14 Firmware and Configuration Maintenance