Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Follow the instructions in the following table to configure IP Alias parameters.
FIELD
IP Alias
Choose Yes to configure the LAN network for the Prestige.
IP Address
Enter the IP address of your Prestige in dotted decimal notation
IP Subnet Mask Your Prestige will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the
subnet mask computed by the Prestige
RIP Direction
SPACE BAR
Press [
In Only or Out Only.
Version
SPACE BAR]
Press [
or RIP-2M.
Incoming
Enter the filter set(s) you wish to apply to the incoming traffic between this
Protocol Filters
node and the Prestige.
Outgoing
Enter the filter set(s) you wish to apply to the outgoing traffic between this
Protocol Filters
node and the Prestige.
When you have completed this menu, press [
ESC
configuration, or press [
27.5 Route IP Setup
The first step is to enable the IP routing in Menu 1 — General Setup.
To edit menu 1, type 1 in the main menu and press [ENTER]. Set the Route IP field to Yes by
pressing [SPACE BAR].
Internet Access
Figure 27-4 Menu 3.2.1 IP Alias Setup
Table 27-1 Menu 3.2.1 IP Alias Setup
DESCRIPTION
] to select the RIP direction. Choices are None, Both,
to select the RIP version. Choices are RIP-1, RIP-2B
ENTER
] at the prompt "Press ENTER to Confirm..." to save your
] at any time to cancel.
Prestige 662HW Series User's Guide
Yes
192.168.2.1
255.255.255.0
None
RIP-1
EXAMPLE
27-3