Table of Contents
Advertisement
NTI Secure Remote Power Reboot Switch
Network Configuration
From the Network Setup page the administrator can either choose to have the IP address and DNS information filled in
automatically by the DHCP server (default setting), or manually fill in the fields (use a static address). To view the Network
Configuration page, click on Network from the Administration section of the menu.
Note: When "DHCP" is selected, make sure a DHCP server is running on the network the IPDU-Sx is connected to.
IP Settings
Mode
IP Address
Subnet Mask
Default Gateway
Preferred DNS
Alternate DNS
For descriptions of SMTP, SNMP, and Server Settings, see page 35.
Figure 36- Network Configuration page
Description
Select between Static (manual) , or DHCP (automatic IP and DNS) settings (DHCP is the
default setting)
Enter a valid IP address (default address shown above)
Enter a valid subnet mask (default value shown above)
Enter a valid gateway (default gateway shown above)
Enter a preferred domain name server address
Enter an alternate domain name server address
Note: The values shown here are
for local (static) address
configuration only.
Address values for DHCP
configuration will only be displayed
in the System Information page
(page 50).
Only applicable to IPDU-S4/S8
models- firmware version 1.4 or
later.
.
33
Advertisement
Table of Contents
