Figure 81- Text Menu-Sensor Alert Settings - Network Technologies IPDU-Sx Installation And Operation Manual

NTI Secure Remote Power Reboot Switch
Sensor Settings Description
Description The description of the sensor that will be viewed in the Summary page and in the body of alert
messages
Group Assign the sensor to either group 1 or 2 (see also page 45)
Units This lets the operator choose between Celsius and Fahrenheit as the temperature
measurement unit.
Min. Level Displays the minimum value that this sensor will report
Max. Level Displays the maximum value that this sensor will report
Minimum Threshold The user must define the lowest acceptable value for the sensors. If the sensor measures a
value below this threshold, the sensor will move to alert status. The assigned value should be
within the range defined by Minimum Level and Maximum Level and lower than the assigned
Maximum Threshold value. If values out of the range are entered, an error message will be
shown.
Maximum Threshold The user must define the highest acceptable value for the sensors. If the sensor measures a
value above this threshold, the sensor will move to alert status. The assigned value should be
within the range defined by Minimum Level and Maximum Level and higher than the assigned
Minimum Threshold value. If values out of the range are entered, an error message will be
shown.
Sampling Period Determines how often the displayed sensor value is refreshed on the Sensor page. A numeric
value and a measurement unit (minimum 1 seconds, maximum 999 minutes) should be entered.
Press <Tab> to highlight Save and press <Enter> to save before pressing <Esc> to exit.
From the Alert Settings menu, the user can enable/disable alert messages to be sent when the sensor is in an alert state and
configure when and how alert messages are sent.

Figure 81- Text Menu-Sensor Alert Settings

69