Table of Contents
Advertisement
NTI Secure Remote Power Reboot Switch
LDAP Account Settings
Common Name (for LDAP)
Organizational Unit (for LDAP)
Contact Settings
Group 1
Group 2
Email alerts
Email address
Syslog alerts
SNMP traps
Syslog/SNMP IP address
SMS Alert
Phone Number
Schedule Settings
Schedule Type
Start Day
End Day
Start Hour
End Hour
"Common Name" assigned in the LDAP server account in an Active Directory. Often a name
assigned that is different than the Username.
"Account Settings" (above), this can be left blank.
Enter the Organizational Unit the user belongs to in an Active Directory
Format is <ou,ou,etc> (like example in Figure 48)
Place a checkmark if the user should receive messages from sensors, IP devices and outlets in
Group 1 (see also pages 24 and 26 for group assignments)
Place a checkmark if the user should receive messages from sensors, IP devices and outlets in
Group 2 (see also pages 24 and 26 for group assignments)
Place a checkmark if the user should receive messages via email
Enter a valid email address if this user should receive email alert messages
Place a checkmark if the user should receive alerts via syslog messages
Place a checkmark if the user should receive alerts via SNMP traps
Enter a valid syslog/SNMP IP address for the user to receive syslog/SNMP messages
Place a checkmark if the user should receive alerts via SMS messages (IPDUS4/S8 only)
Enter a phone number for the GSM modem to call to alert the user via SMS message
Always active- user will receive messages at all hours of each day
Active during defined times- user will only receive alert messages during times as
First day of the week the user should begin receiving messages
Last day of the week the user should receive messages
Note: Start Day and End Day must be different, or no messages will be sent.
First hour of the day the user should begin receiving messages
Last hour of the day the user should receive messages
If this is the same as the Username in the
outlined below
45
Advertisement
Table of Contents
