Table of Contents
Advertisement
NTI Secure Remote Power Reboot Switch
Cascade Notification
In the event a slave goes offline from the system, the system can be set to notify those configured to receive messages from the
master unit. In the Cascade menu under Administration, the "Cascade Notification Settings" menu provides a place to configure
how frequent notifications will be repeated. Cascade Notification cannot be disabled.
Figure 45- Cascade Notification Settings
An example of the notification you will receive is:
Slave Unit #2 (Unit Name) not
11-12-2010 11:18:38 AM
Sensor Not Responding
--
responding
Suggestion: To avoid receiving unnecessary notifications, don't enable the slave (Figure 43 and Figure 44) when
configuring the master until the slave has been fully configured first.
The default time period in which notifications will repeat is every 30 seconds.
The number value range for the time period is 1-99, and the units can be seconds (Sec), minutes (Min), or hours (Hr).
42
Advertisement
Table of Contents
