Table of Contents
Advertisement
NTI Secure Remote Power Reboot Switch
Once events are configured, they are listed and numbered for monitoring and easy adjustment. Up to 50 can be configured.
Figure 32- List of Configured Event
If an event is triggered, the Status will change from "Normal" to "Alarm". Whatever reaction that has been configured as a result
of this event will be activated.
The user will have the option to either Acknowledge the alert, Dismiss it, or Delete the configuration of the event altogether.
If the user acknowledges the alert, no additional alert messages will be sent during that alert status cycle.
If the user dismisses
the alert, another alert message will be sent once the "notify again after" time designated on the configuration page elapses.
To see the status page for a sensor, click on the link under "Curr. Val.".
To see the status of an associated outlet, click on the
link under "Assoc Outlet".
To delete an event configuration, select "Delete" to the far right of the event number. That configuration will be removed and the
one following it (if any) will move up to that event number.
Note: Removal of a sensor from the IPDU will also remove all configured events associated with that sensor.
Click on the description for an event to open the configuration page for editing.
Figure 33- Adjust settings for events
All settings for an event can be adjusted as needed. Be sure to click "Save" before exiting.
29
Advertisement
Table of Contents
