Table of Contents
Advertisement
NTI Secure Remote Power Reboot Switch
RS485 Slave
If the type is RS485 Slave, an address number (1-255) must be entered to identify the unit to the master. Each slave on the
system must have a unique address number.
Ethernet Slave
If the type is Ethernet Slave, the Ethernet address entered on the Network Configuration page (page 33) will be used by the
master to communicate with this slave. Each slave on the system must have a unique IP address.
Figure 41- Configure as RS485 Slave
Figure 42- Configure as Ethernet Slave
39
Advertisement
Table of Contents
