Table of Contents
Advertisement
NTI Secure Remote Power Reboot Switch
Alert Settings
Disable alerts
Alert Delay
Notify Again Time
Notify on Return to Normal
Auto Acknowledge
Alert Settings
Enable Email Alerts
Enable Syslog Alerts
Enable SNMP traps
Enable SMS Alerts
Email Subject
Press <Tab> to highlight Save and press <Enter> to save before pressing <Esc> to exit.
Change to "Yes" to prevent alerts from being sent when this sensor's status changes
The alert delay is an amount of time the sensor must be in an alert condition before an alert is
sent. This provides some protection against false alarms. The Alert Delay value can be set
for 0-999 seconds or minutes.
Enter the amount of time in seconds, minutes, or hours (1-999) before an alert message will be
repeated
The user can also be notified when the sensor readings have returned to the normal range by
changing to "Yes" for "Notify on return to normal" for a sensor.
Change to "Yes" to have alert notifications in the summary page return to normal state
automatically when sensor readings return to normal.
Change to "Yes" to have alert notifications sent via Email
Change to "Yes" to have alert notifications sent via Syslog messages
Change to "Yes" to have alert notifications sent via SNMP traps (v2c)
Change to "Yes" to have alert notifications sent via SMS (requires GSM modem)
Enter the subject to be viewed when an email alert message is received
70
Advertisement
Table of Contents
