Table of Contents
Advertisement
NTI Secure Remote Power Reboot Switch
OPERATION VIA TEXT MENU- IPDU-SX
The IPDU-Sx can be controlled using a terminal program (e.g. HyperTerminal) via an RS232-Link, connected to Console Port
(page 6) or using Telnet or SSH protocol via the Ethernet Port. Either of these methods will work to access the IPDU-Sx text
menu. The text menu can be used to control all functions of the IPDU-Sx as an alternative to the Web Interface (page 14).
Connection Via Console Port
The following instruction will enable the user to quickly make connections using a terminal connected to the
"CONSOLE" port. For instruction to make quick connection using the Ethernet port and Web Interface, see page 14.
1.
Make sure the IPDU-Sx is turned OFF.
2.
Using the serial console device connected to the port labeled "CONSOLE", start the terminal program (e.g. Windows
HyperTerminal) and configure it as follows:
•
direct connection (using the appropriate CPU local serial Com port)
•
115200 bps
•
8 bits
•
no parity
•
1 stop bit
•
no flow control
•
VT100 terminal mode.
3.
Power ON the IPDU-Sx. Wait for the IPDU-SX login prompt.
root
4.
At "Username: " type <
nti
5.
At "Password" type <
Note: User names and passwords are case sensitive. It is important to know what characters must be capitalized and
what characters must not.
> (all lowercase letters) and press <Enter>.
> (all lowercase letters) and press <Enter>.
Figure 64- Text Menu Login screen
58
Advertisement
Table of Contents
