Additional Modes Available With Security; Administration Mode; Switch Configuration; Figure 10- Administration Mode Menu - Network Technologies ST-xUO Installation And Operation Manual

NTI NODEMUX SERIES UNIVERSAL KVM SWITCH

Additional Modes Available With Security

Note: The three modes that follow are only available if the administrator is logged in.

Administration Mode

Administration Mode allows the administrator to use the following functions:
Function:
Configure switch- for application
and RS232 communication
(not found in legacy NODEMUX)
Change the administrator's
password
Enter User Name List Mode
Disable security
Selects the idle time in seconds
Exit Administration Mode and
return to previous mode

Switch Configuration

Switch Configuration enables the administrator to configure the NODEMUX to be used as a stand alone switch or as one of the
switches in a cascaded system.
Note: Cascading is no longer supported in this switch. Be careful not to change this field to anything except "STAND
ALONE SWITCH".
Switch Configuration is also used to setup the communication settings for RS232 communication with a remotely connected
terminal through the RS232 port.
(above).
Be careful with
this field. If
changed to
"SLAVE", OSD
will not work after
power cycling.
Keystroke:
W
C
U
S
T - -
(0-2)
x
Esc
For the Switch Configuration Mode menu, press <W> from the Administration Mode menu

Figure 11- Switch Configuration Mode screen

11

Figure 10- Administration Mode menu

(xxx from 000 to 255. ie. t002
(0-9) - (0-9)
would set the time-out period
x x
for 2 seconds. 000 will disable it)
In the event the setting is changed
from "stand alone" to "slave", when
the switch is power cycled the OSD
menu will no longer work. To restore
the setting back to "stand alone",
factory default settings must be
restored via a terminal connected to
the RS232 control port. See the
RS232 Command "CF" on page 24 to
restore default settings.