Table of Contents
Advertisement
NTI Secure Remote Power Reboot Switch
RS485 Slave
If the type is RS485 Slave, an address number (1-255) must be entered to identify the unit to the master. Each slave on the
system must have a unique address number.
Figure 103- Text Menu- Unit RS485 Address
Ethernet Slave
If the type is Ethernet Slave, the Ethernet address entered on the Network Configuration page (page 33) will be used by the
master to communicate with this slave. There will be no "slave IP address settings" to enter.
Each slave on the system must
have a unique IP address.
Figure 104- Text Menu- Type is Ethernet Slave
86
Advertisement
Table of Contents
