Table of Contents
Advertisement
NTI Secure Remote Power Reboot Switch
Ethernet Master
If the type is Ethernet Master, then the Slave IP Address Settings (item 2 in the Cascade Configuration menu) must be entered
for each slave that will be controlled. RS485 address settings and the RS485 unit address will not apply. To configure a slave to
be connected, select the desired slave number and press <Enter> to open the "Edit Slave Address" menu.
Figure 107- Text Menu- Ethernet Master's slave list
In the "Edit Slave Address" menu, the slave can be either enabled (set to establish communication with the slave) or left disabled.
If set to enable, be sure to enter a valid unique IP address.
Figure 108-Text Menu- Edit Ethernet Slave Address
88
Advertisement
Table of Contents
