Ipv4 Route Table - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
VRF Name
IP Address
Netmask
Gateway
Backup State
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.

IPv4 Route Table

On this page, users can view and configure the IPv4 route table settings. To view the following window,
click L3 Features > IPv4 Route Table, as shown below:
Figure 6-8 IPv4 Static/Default Route Window
Description
Enter the VRF instance name used here. This name can be up to 12
characters long.
Enter the IPv4 address for this route here. Tick the Default Route
option to use the default route as the IPv4 address.
Enter the IPv4 network mask for this route here.
Enter the gateway address for this route here.
Select the backup state option here. Options to choose from are
Primary, Backup, and Weight. When the Primary option is selected,
the route will be used as the primary route to the destination. When the
Backup option is selected, the route will be used as the backup route
to the destination. When the Weight option is selected, the weight
number must be entered with value greater than zero, but less than the
maximum paths number. This number is used to replicate identical
route path (multiple copies) in routing table, so the path get more
chance to be hit for traffic routing. If weight number is not specified for
the static route, the default for the path that exists in the hashing table
is one copy. This value must be between 1 and 32.
Figure 6-9 IPv4 Route Table Window
57