D-Link DXS-3600 Series Reference Manual page 210

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Tag field value
0x01
0x02
Others
(0x00, 0x03 ~ 0x1F, >0x1F)
Note: A tag field of greater than 0x1F is interpreted as the first octet of the following field.
If the user has configured the VLAN attribute of the RADIUS server (for example, VID 3) and the 802.1X,
or MAC based Access Control, or WAC authentication is successful, the port will be assigned to VLAN 3.
However if the user does not configure the VLAN attributes, when the port is not guest VLAN member, it
will be kept in its current authentication VLAN, and when the port is guest VLAN member, it will be
assigned to its original VLAN.
To assign the ACL by the RADIUS server, the proper parameters should be configured on the RADIUS
server. The table below shows the parameters for an ACL.
The parameters of the Vendor-Specific Attribute are:
RADIUS Tunnel Attribute
Vendor-ID
Vendor-Type
Attribute-Specific Field
If the user has configured the ACL attribute of the RADIUS server (for example, ACL script: ip access-list
a1;permit host 10.90.90.100;exit; mac access-list extended m1;permit host 00-00-00-01-90-10 any; exit;),
and the 802.1X or MAC-based Access Control WAC is successful, the device will assign the ACL script
according to the RADIUS server. The enter Access-List Configuration Mode and exit Access-List
Configuration Mode must be a pair, otherwise the ACP script will be reject. For more information about
the ACL module, please refer to Access Control List (ACL) Commands chapter.
String field format
VLAN name (ASCII)
VLAN ID (ASCII)
When the switch receives the VLAN setting string, it will think it is the
VLAN ID first. In other words, the switch will check all existing VLAN
IDs and check if there is one matched. If the switch can find one
matched, it will move to that VLAN. If the switch cannot find the
matched VLAN ID, it will think the VLAN setting string as a "VLAN
Name". Then it will check that it can find out a matched VLAN Name.
Description
Defines the vendor.
Defines the attribute.
Used to assign the ACL
script. The format is based
on Access Control List
(ACL) Commands.
205
Value
171 (DLINK)
14 (for ACL script)
ACL Script
For example:
ip access-list a1;permit
host 10.90.90.100;exit;
mac access-list
extended m1;permit host
00-00-00-01-90-10 any;
exit;
Usage
Required
Required
Required