D-Link DXS-3600 Series Reference Manual page 85

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
Rule Number
Action
Source
Destination
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
To enable the Counter State option or to enter a Remark for the profile, click the Edit button, next to the
specific ACL profile (found in the ACL profile table).
Figure 8-5 Standard IP ACL (Add Rule) Window
Description
Enter the ACL rule number here. This value must be between 1 and
65535. If this value is not specified, the system will automatically
generate an ACL rule number for this entry.
Select the action that this rule will take here. Options to choose from
are Permit and Deny.
Select and enter the source information here. Options to choose from
are Any, Host, IP, and Wildcard. When the Any option is selected,
any source traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the source host's IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of source IP addresses by using a
wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
from are Any, Host, IP, and Wildcard. When the Any option is
selected, any destination traffic will be evaluated according to the
conditions of this rule. When the Host option is selected, enter the
destination host's IP address here. When the IP option is selected, the
Wildcard option will also be available. Enter the group of destination
IP addresses by using a wildcard bitmap. The bit corresponding to the
bit value 1 will be ignored. The bit corresponding to the bit value 0 will
be checked.
80