Queue Rate Limiting - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
The fields that can be configured are described below:
Parameter
From Port ~ To Port
Direction
Rate Limit
Click the Apply button to accept the changes made.

Queue Rate Limiting

On this page, users can view and configure the queue rate limiting settings. To view the following window,
click QoS > Basic Settings > Queue Rate Limiting, as shown below:
Figure 7-5 Port Rate Limiting Window
Description
Select the range of ports that will be used for this configuration here.
Select the direction option here. Options to choose from are Input and
Output. When Input is selected, the rate limit for ingress packets is
configured. When Output is selected, the rate limit for egress packets
is configured.
Select and enter the rate limit value here.
When Bandwidth is selected, enter the input/output bandwidth value
used in the space provided. This value must be between 8 and
10000000 kbps. Also, enter the Burst Size value in the space
provided. This value must be between 0 and 128000 kilobytes.
When Percent is selected, enter the input/output bandwidth
percentage value used in the space provided. This value must be
between 1 and 100 percent (%). Also, enter the Burst Size value in
the space provided. This value must be between 0 and 128000
kilobytes.
Select the None option to remove the rate limit on the specified port(s).
The specified limitation cannot exceed the maximum speed of the
specified interface. For the ingress bandwidth limitation, the ingress
will send a pause frame or a flow control frame when the received
traffic exceeds the limitation.
Figure 7-6 Queue Rate Limiting Window
66