D-Link DXS-3600 Series Reference Manual page 77

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Multiple Match Criteria
Click the Apply button to accept the changes made.
Click the Match button to configure the specific entry.
Click the Delete button to remove the specific entry.
After clicking the Match button, the following page will be available.
The fields that can be configured are described below:
Parameter
None
Specify
Access List Name
CoS List
DSCP List
Precedence List
Protocol Name
VLAN List
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
Select the multiple match criteria option here. Options to choose from
are Match All and Match Any.
Figure 7-13 Class Map (Match) Window
Description
Select this option to match nothing to this class map.
Select the option to match something to this class map.
Select and enter the access list name that will be matched with this
class map here. This name can be up to 32 characters long.
Select and enter the CoS list value that will be matched with this class
map here. This value must be between 0 and 7. Tick the Inner option
to match the inner most CoS of QinQ packets on a Layer 2 class of
service (CoS) marking.
Select and enter the DSCP list value that will be matched with this
class map here. This value must be between 0 and 63. Tick the IPv4
only option to match IPv4 packets only. If not specified, the match is
for both IPv4 and IPv6 packets.
Select and enter the precedence list value that will be matched with
this class map here. This value must be between 0 and 7. Tick the
IPv6 only option to match IPv6 packets only. If not specified, the
match is for both IPv4 and IPv6 packets. For IPv6 packets, the
precedence is most three significant bits of traffic class of IPv6 header.
Select the protocol name that will be matched with the class map here.
Options to choose from are ARP, BGP, DHCP, DNS, EGP, FTP, IPv4,
IPv6, NetBIOS, NFC, NTP, OSPF, PPPOE, RIP, RSTP, SSH, Telnet,
and TFTP.
Select and enter the VLAN list value that will be matched with the class
map here. This value must be between 1 and 4094. Tick the Inner
option to match the inner-most VLAN ID in an 802.1Q double tagged
frame.
72