D-Link DXS-3600 Series Reference Manual page 93

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Destination
Specify ICMP Message Type
ICMP Message Type
Message Code
IP Precedence
ToS
DSCP
Time Range
After selecting the EIGRP option as the Protocol Type, the following page and parameters will be
available, as shown below:
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of source IP addresses by using a
wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
from are Any, Host, IP, and Wildcard. When the Any option is
selected, any destination traffic will be evaluated according to the
conditions of this rule. When the Host option is selected, enter the
destination host's IP address here. When the IP option is selected, the
Wildcard option will also be available. Enter the group of destination
IP addresses by using a wildcard bitmap. The bit corresponding to the
bit value 1 will be ignored. The bit corresponding to the bit value 0 will
be checked.
Select the ICMP message type used here.
When the ICMP Message Type is not selected, enter the ICMP
Message Type numerical value used here. When the ICMP Message
Type is selected, this numerical value will automatically be entered.
When the ICMP Message Type is not selected, enter the Message
Code numerical value used here. When the ICMP Message Type is
selected, this numerical value will automatically be entered.
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network). After selecting the IP
precedence value, select the Type-of-Service (ToS) value that will be
used here. Options to choose from are 0 (normal), 1 (min-monetary-
cost), 2 (max-reliability), 3, 4 (max-throughput), 5, 6, 7, 8 (min-
delay), 9, 10, 11, 12, 13, 14, and 15.
Select the Type of Service option here. Options to choose from are 0
to 15.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the time profile name that will be associated with this ACL rule,
here.
88