D-Link DXS-3600 Series Reference Manual page 53

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
configured on the Switch, STP will block one entire group; in the same way STP will block a single port
that has a redundant link.
NOTE: If any ports within the trunk group become disconnected, packets intended for the
disconnected port will be load shared among the other linked ports of the link aggregation
group.
On this page, users can view and configure the link aggregation settings. To view the following window,
click L2 Features > Link Aggregation, as shown below:
The fields that can be configured for Link Aggregation are described below:
Parameter
System Priority
Load Balance Algorithm
Click the Apply button to accept the changes made.
The fields that can be configured for Trunking Information are described below:
Parameter
From Port ~ To Port
Channel Group
Mode
Figure 5-33 Link Aggregation Window
Description
Enter the system's priority value used here. This value must be
between 1 and 65535. By default, this value is 32768. The system
priority determines which ports can join a port-channel and which ports
are put in the stand-alone mode. The lower value has a higher priority.
If two or more ports have the same priority, the port number
determines the priority
Select the load balancing algorithm that will be used here. Options to
choose from are Source MAC, Destination MAC, Source
Destination MAC, Source IP, Destination IP, Source Destination
IP, Source L4 Port, Destination L4 Port, and Source Destination L4
Port. By default, this option is Source Destination MAC.
Description
Select the list of ports that will be associated with this configuration
here.
Enter the channel group number here. This value must be between 1
and 16. The system will automatically create the port-channel when a
physical port first joins a channel group. An interface can only join one
channel-group.
Select the mode option here. Options to choose from are On, Active,
and Passive. If the mode On is specified, the channel group type is
static. If the mode Active or Passive is specified, the channel group
type is LACP. A channel group can only consist of either static
48