Proxy Arp; Arp Table - D-Link DXS-3600 Series Reference Manual

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Parameter
VRF Name
IP Address
Hardware Address
Click the Apply button to accept the changes made.
Click the Find button to find the entry, based on the information entered.
Click the Edit button to re-configure the specific entry.
Click the Delete button to remove the specific entry.

Proxy ARP

On this page, users can view and configure the proxy ARP settings. The Proxy ARP feature of the switch
will allow the switch to reply to ARP requests destined for another device by faking its identity (IP and
MAC Address) as the original ARP responder. Therefore, the switch can then route packets to the
intended destination without configuring static routing or a default gateway. The host, usually a Layer 3
switch, will respond to packets destined for another device. To view the following window, click L3
Features > ARP > Proxy ARP, as shown below:
The fields that can be configured are described below:
Parameter
Proxy ARP State
Local Proxy ARP State
Click the Apply button to accept the changes made.
Click the Edit button to re-configure the specific entry.

ARP Table

On this page, users can view and configure the ARP table settings. To view the following window, click L3
Features > ARP > ARP Table, as shown below:
Description
Enter the Virtual Routing and Forwarding (VRF) instance name used
here. This name can be up to 12 characters long.
Enter the IP address that will be associated with the MAC address
here.
Enter the MAC address that will be associated with the IP address
here.
Figure 6-3 Proxy ARP Window
Description
Select to enable or disable the proxy ARP state here.
Select to enable or disable the local proxy ARP state here. This local
proxy ARP function allows the switch to respond to the proxy ARP, if
the source IP and destination IP are in the same interface.
53