D-Link DXS-3600 Series Reference Manual page 89

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Protocol Type
After selecting the TCP option as the Protocol Type, the following page and parameters will be available,
as shown below:
The dynamic fields that can be configured are described below:
Parameter
Source
Destination
Source Port
Select the protocol type option here. Options to choose from are TCP,
UDP, ICMP, EIGRP, ESP, GRE, IGMP, OSPF, PIM, VRRP, IP-in-IP,
PCP, Protocol ID, and None.
Figure 8-12 Extend IP ACL (Add Rule) TCP Window
Description
Select and enter the source information here. Options to choose from
are Any, Host, IP, and Wildcard. When the Any option is selected,
any source traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the source host's IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of source IP addresses by using a
wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
Select and enter the destination information here. Options to choose
from are Any, Host, IP, and Wildcard. When the Any option is
selected, any destination traffic will be evaluated according to the
conditions of this rule. When the Host option is selected, enter the
destination host's IP address here. When the IP option is selected, the
Wildcard option will also be available. Enter the group of destination
IP addresses by using a wildcard bitmap. The bit corresponding to the
bit value 1 will be ignored. The bit corresponding to the bit value 0 will
be checked.
Select and enter the source port value here. Options to choose from
are =, >, <, ≠, and Range. When selecting the = option, the specific
selected port number will be used. When selecting the > option, all
84