D-Link DXS-3600 Series Reference Manual page 135

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
IP Precedence
ToS
DSCP
Outer VID
Inner VID
CoS
Inner CoS
Time Range
After selecting the ESP option as the Protocol Type, the following page and parameters will be available,
as shown below:
The dynamic fields that can be configured are described below:
Parameter
selected, the Wildcard option will also be available. Enter the
destination MAC address and wildcard value in the spaces provided.
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network). After selecting the IP
precedence value, select the Type-of-Service (ToS) value that will be
used here. Options to choose from are 0 (normal), 1 (min-monetary-
cost), 2 (max-reliability), 3, 4 (max-throughput), 5, 6, 7, 8 (min-
delay), 9, 10, 11, 12, 13, 14, and 15.
Select the Type of Service option here. Options to choose from are 0
to 15.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the outer VLAN ID that will be associated with this ACL rule
here. This value must be between 1 and 4094.
Enter the inner VLAN ID that will be associated with this ACL rule here.
This value must be between 1 and 4094.
Select the Class of Service (CoS) value here. Options to choose from
are from 0 to 7.
Select the inner Class of Service (CoS) value here. Options to choose
from are from 0 to 7.
Enter the time profile name that will be associated with this ACL rule,
here.
Figure 8-62 Expert ACL (Add Rule) ESP Window
Description
130