D-Link DXS-3600 Series Reference Manual page 112

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Protocol Type
After selecting the TCP option as the Protocol Type, the following page and parameters will be available,
as shown below:
The dynamic fields that can be configured are described below:
Parameter
Source
Destination
Source Port
are Permit and Deny.
Select the protocol type option here. Options to choose from are TCP,
UDP, ICMP, Protocol ID, ESP, PCP, SCTP, and None.
Figure 8-38 Extend IPv6 ACL (Add Rule) TCP Window
Description
Select and enter the source information here. Options to choose from
are Any, Host, IPv6, and Prefix Length. When the Any option is
selected, any source traffic will be evaluated according to the
conditions of this rule. When the Host option is selected, enter the
source host's IPv6 address here. When the IPv6 option is selected, the
Prefix Length option will also be available. Enter the source IPv6
address and prefix length value in the spaces provided.
Select and enter the destination information here. Options to choose
from are Any, Host, IPv6, and Prefix Length. When the Any option is
selected, any destination traffic will be evaluated according to the
conditions of this rule. When the Host option is selected, enter the
destination host's IPv6 address here. When the IPv6 option is
selected, the Prefix Length option will also be available. Enter the
destination IPv6 address and prefix length value in the spaces
provided.
Select and enter the source port value here. Options to choose from
are =, >, <, ≠, and Range. When selecting the = option, the specific
selected port number will be used. When selecting the > option, all
ports greater than the selected port, will be used. When selecting the <
option, all ports smaller than the selected port, will be used. When
selecting the ≠ option, all ports, excluding the selected port, will be
107