D-Link DXS-3600 Series Reference Manual page 90

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Destination Port
TCP Flag
IP Precedence
ToS
DSCP
Time Range
After selecting the UDP option as the Protocol Type, the following page and parameters will be available,
as shown below:
ports greater than the selected port, will be used. When selecting the <
option, all ports smaller than the selected port, will be used. When
selecting the ≠ option, all ports, excluding the selected port, will be
used. When selecting the Range option, the start port number and end
port number selected, of the range, will be used. Alternatively, the port
number(s) can manually be entered in the space(s) provided, if the
port number(s) is/are not available in the drop-down list.
Select and enter the destination port value here. Options to choose
from are =, >, <, ≠, and Range. When selecting the = option, the
specific selected port number will be used. When selecting the >
option, all ports greater than the selected port, will be used. When
selecting the < option, all ports smaller than the selected port, will be
used. When selecting the ≠ option, all ports, excluding the selected
port, will be used. When selecting the Range option, the start port
number and end port number selected, of the range, will be used.
Alternatively, the port number(s) can manually be entered in the
space(s) provided, if the port number(s) is/are not available in the
drop-down list.
Tick the appropriate TCP flag option to include the flag in this rule.
Options to choose from are ack, fin, psh, rst, syn, and urg.
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network). After selecting the IP
precedence value, select the Type-of-Service (ToS) value that will be
used here. Options to choose from are 0 (normal), 1 (min-monetary-
cost), 2 (max-reliability), 3, 4 (max-throughput), 5, 6, 7, 8 (min-
delay), 9, 10, 11, 12, 13, 14, and 15.
Select the Type of Service option here. Options to choose from are 0
to 15.
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Enter the time profile name that will be associated with this ACL rule,
here.
85