D-Link DXS-3600 Series Reference Manual page 79

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch Web UI Reference Guide
Violate Action
Color Aware
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
After selecting the Two Rate Setting tab option, at the top of the page, the following page will be
available.
The fields that can be configured are described below:
new IP DSCP value.
When selecting the Set-1P-Transmit option, enter the 1P transmit
value in the space provided. This value sets the 802.1p value and
transmits the packet with the new value.
When selecting the Set-DSCP-1P option, enter the IP DSCP and 1P
transmit values in the spaces provided.
When selecting the Transmit option, packets will be transmitted
unaltered.
Select the violate action here. The violate action specifies the action to
take on packets that violate the normal and maximum burst sizes for
singe rate policing. It specifies the action to take for those packets that
did not conform to both CIR and PIR. For a single rate policer, if the
violate action is not specified, it will create a single-rate two-color
policer. For a two-rate policer, if the violation action is not specified, the
default action is equal to the exceed action. Options to choose from
are Drop, Set-DSCP-Transmit, Set-1P-Transmit, Transmit, and Set-
DSCP-1P.
When selecting the Drop option, the packet will be dropped.
When selecting the Set-DSCP-Transmit option, enter the IP DSCP
value in the space provided. This value sets the IP differentiated
services code point (DSCP) value and transmits the packet with the
new IP DSCP value.
When selecting the Set-1P-Transmit option, enter the 1P transmit
value in the space provided. This value sets the 802.1p value and
transmits the packet with the new value.
When selecting the Set-DSCP-1P option, enter the IP DSCP and 1P
transmit values in the spaces provided.
When selecting the Transmit option, packets will be transmitted
unaltered.
Select the color aware option here. Options to choose from are None
and Enabled. When color aware is not specified, the policer works in
the color blind mode. When color aware is enabled, the policer works
in the color aware mode.
Figure 7-15 Aggregate Policer (Two Rate Setting) Window
74