Filter Replacement; Ceiling Mount Installation - Christie D12HD-H User Manual

3.9

Filter Replacement

1. Turn off the projector.
2. Wait for projector to cool down: Allow the projector to cool down into
standby mode.
3. Remove the filter cover by pushing down it.
4. Release the filter by pulling out and replace it.
3.10

Ceiling Mount Installation

Mount the projector with an appropriate mounting kit, using the four mounting
points on the underside of the projector.
• When not mounted properly, the projector may fall, causing hazards or
injury. The warranty on this projector does not cover any damage caused
by the use of any non-recommended ceiling mount kit or installation of the
ceiling mount kit in an improper location.
• Refer to the installation instructions and safety guidelines provided in the
kit.
H Series User Manual
020-000772-02 Rev.1 (08-2015)
Section 3: INSTALLATION
3-12