Installing A Serveraid Sas Controller Battery On The Remote Battery Tray - IBM System x3650 M4 Type 7915 Problem Determination And Service Manual

4. Press the release tab toward the fan cage and unlock the battery retention clip.
5. Disconnect the battery cable from the battery cable connector on the battery.
6. Lift the battery up to remove the battery from the battery holder.
If you are instructed to return the ServeRAID adapter battery, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to you.
Installing a ServeRAID SAS controller battery on the remote battery
tray
When you install any ServeRAID adapter that comes with batteries, it is sometimes
necessary to install the batteries in another location in the server to prevent the
batteries from overheating. The batteries must be installed near the fan cage. To
install a ServeRAID adapter battery in the server, complete the following steps:
Note: If you are installing ServeRAID-M5100 Series 512 MB cache RAID 5
upgrade that comes with a battery, you must install the battery in ServeRAID SAS
controller remote battery retention instead (see "Installing an optional ServeRAID
SAS controller battery holder" on page 209).
232
IBM System x3650 M4 Type 7915: Problem Determination and Service Guide
Battery
Battery cable
connector