IBM System x3650 M4 Type 7915 Problem Determination And Service Manual page 294

CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
See the IBM Environmental Notices and User's Guide on the IBM Documentation
CD for more information.
To install the replacement battery, complete the following steps:
1. Follow any special handling and installation instructions that come with the
2. Insert the new battery:
3. Reinstall any adapters that you removed.
276
IBM System x3650 M4 Type 7915: Problem Determination and Service Guide
replacement battery.
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
Battery
b. Press the battery down into the socket until it clicks into place. Make sure
that the battery clip holds the battery securely.
c. If you removed a rubber cover from the battery holder, use your fingers to
install the battery cover on top of the battery connector.