Installing A Serveraid Sas Controller Battery On The Remote Battery Tray - IBM x3650 M3 Installation And User Manual

Figure 145. ServeRAID adapter advanced feature key installation
Results
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 154.
Installing a ServeRAID SAS controller battery on the remote battery
tray
Use this information to install a ServeRAID SAS controller battery on the remote
battery tray.
About this task
Note: For brevity, in this documentation the Intelligent Battery Backup Unit (iBBU)
is often referred to as the battery.
When you install a ServeRAID SAS controller in a PCI riser-card assembly in the
server, you must install the battery at a distance from the ServeRAID controller to
avoid overheating. This section describes the process for installing a battery or
batteries in the server.
To install a battery, complete the following steps:
Procedure
1. Read the safety information that begins on page "Safety" on page v and
"Installation guidelines" on page 37.
Chapter 2. Installing optional devices
139