IBM System x3650 M4 Type 7915 Problem Determination And Service Manual page 279

Power supply
filler panel
Attention: During normal operation, each power-supply bay must contain either a
power supply or power-supply filler for proper cooling.
To install a power supply, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
on page 191.
2. Touch the static-protective package that contains the hot-swap power supply to
any unpainted metal surface on the server; then, remove the power supply from
the package and place it on a static-protective surface.
3. If you are adding a power supply to the server, attach the redundant power
information label that comes with this option on the server cover near the power
supplies.
Power supplies
4. Slide the power supply into the bay until the retention latch clicks into place.
Attention: Do not install the different power rating or wattage of power
supplies, high-efficiency and non-high-efficiency power supplies in the server.
5. Connect the power cord for the new power supply to the power-cord connector
on the power supply.
The following illustration shows the power-cord connectors on the back of the
server.
Hot-swap
power supply 2
XXXW ~ AC
1 2
xxx-xxx/
xxx-xxxV~
x,x/x,x A
xx/xx Hz
Chapter 5. Removing and replacing server components
XXXW ~ AC
xxx-xxx/
xxx-xxxV~
x,x/x,x A
xx/xx Hz
261